DiyLightAnimation
Software => xlights => Topic started by: rmp2917 on December 05, 2011,
-
Is there any way to set the same channels for multiple dongles in xlights?
I have a standard Lynx dongle and a pixelnet dongle. I want channels 1-84 to be on the standard dongle and also on the pixelnet dongle. I did this so that I could run the wireless from the standard dongle and not have to put the wireless transmitter out in the yard with the pixelnet hub, but I would still be able to use the DMX out from the hub where needed.
I setup one network for DMX ending on channel 84 and a second network for Pixelnet ending on channel 1488. It seems to work OK in test mode, but when I run a sequence only the first network seems to work correctly no matter which order I put them in.
The setup works fine in Vixen, but I was wanting to try xlights to see if I get better performance.
-
From what I understand I do not believe your setup would work. xLights sees two different networks and is only reading data from your sequences for 1 network.
What you could do is copy all the channels and events for channels 1-84 and have them in two networks.
Are you using Vixen or LOR? I can probably help you with the LOR side but I have no real experience with Vixen.
Frank
-
Frank is correct.
Matt