DiyLightAnimation

Hardware => Lynx Aether => Topic started by: Gary on July 19, 2010,

Title: Setting Channels for Aether
Post by: Gary on July 19, 2010,

This thing isn't even out yet, but I'd like to know how you set the channel numbers for the Aether? I don't think I saw anything like on the Express with the 3-digit LEDs on it. I don't see DIP switches, either. Those are soooo passé.  ;D

Title: Re: Setting Channels for Aether
Post by: RJ on July 19, 2010,

With the Lynx Address Utility of Course  ;D

RJ

Title: Re: Setting Channels for Aether
Post by: Gary on October 18, 2010,

I'm lining my RGB ducks up for December... hopefully.

When is the Address Utility bring released?

Title: Re: Setting Channels for Aether
Post by: Rainlover on October 18, 2010,

Gary,
The Lynx Address Utility is on the WIKI.
http://diylightanimation.com/wiki/index.php?title=Software
Look under Lynx Software.
I haven't used it yet, but I bet it is easy to use like all of RJ's stuff.

John

Title: Re: Setting Channels for Aether
Post by: Gary on October 22, 2010,

Oh... wait a sec... *LYNX* Address Utility... I guess it was out for a while already... I thought RJ said *AETHER* Address Utility! One program for two products. Now I get it.  :-[