I have my etherdongle with conductor set up to run my show and don't want to mess with it by flashing back to ED firmware and I don't want to reflash the SS controllers with the test firmware and have to flash them back. I just want to test my SS lights on my display. I have a USB dongle flashed with Pixelnet firmware that I should be able to use for this, but nothing is happening. My megatree is the first 4080 channels. The rest of my display starts at channel 4097 so I have 2 universes that are conveniently segregated. My setup in xlights looks like the attached.
Since I am only trying to test the channels above 4096 right now, I have a "dummy" network using E1.31 for the first 4096 and then I have my USB dongle configured for the next 2300. I have my hub set to universe 2 (also tried switching it to universe 1 BTW), but no lights come on with either setting. When I test, the green light on the dongle begins flashing like it is receiving something, but no lights in the display flash. My test configuration is shown in the other attachment. Can anyone (or everyone) see where i have gone wrong? Also, I did verify that the dongle was in fact using COM4. This is the same gear and settings as I used in my show last year, just want to make sure it all works before I put stuff up.
TIA,
-Keith