Both the "Remove for Wireless" and "Terminate" jumpers are in place. Also wanted to mention using Windows 7 Ultimate, 32-bit and Microsoft.Net Framework 4.0. When I programmed the LE I verified the checksum was 6538. One thing I did forget to mention was that when I went to program the LE the PICkit software stated "New firmware must be downloaded for PICkit3 to work with the part selected. Click 'OK' to continue." I had downloaded the PICkit 3 Stand Alone Programmer App software from the link for the PICkit 3 from the Software WIKI page. (My PICkit software info: Application Ver 1.0.0.0, Device File Ver 00.00.00, JAM Ver 01.27.15-06, RS: 01.15.03, AP: 01.12.02-01) I click OK, the PICkit status status light goes red and it seems to do what it needs to. The PICkit software screen reads "Writing AP 01.12.02-01...done" The green bar is ALMOST all the way to the end, but quite does not finish and by now the PICkit status light is back to green.