DiyLightAnimation

Software => Nutcracker: RGB Effects Builder => Topic started by: Rich Renn on December 31, 2013,

Title: E1.31 set for Pixelnet EtherDongle in Nutcracker
Post by: Rich Renn on December 31, 2013,

Hello I know this could be a stupid question and I am just missing some thing, but I am trying to figure out how to set up the Pixelnet EtherDongle in Xlights\Nutcracker I see the usb pixelnet set up but I have two E1.31 EtherDongels to set up for my Zeus boards for next years show. by the way Xlights\Nutcarker the most awesome tool I have used.




Thanks
Richard

Title: Re: E1.31 set for Pixelnet EtherDongle in Nutcracker
Post by: taybrynn on December 31, 2013,

You just add the first one, specify 32 universes starting at 1 ... then add the second etherdongle and have it start at universe 33.

One of the tricky things is you have to flash your second etherdongle with slightly different firmware thats set for the upper 32 universes of pixelnet.  CHeck the wiki for the etherdongle to find that upper universes firmware link.

Title: Re: E1.31 set for Pixelnet EtherDongle in Nutcracker
Post by: Rich Renn on December 31, 2013,

Thanks I found the firmware and how that needed to be done just wanted to make sure I was setting it up right in the set up tab




Thanks
Richard