DiyLightAnimation
Hardware => Lynx Express => Topic started by: Jeffl on February 26, 2010,
-
Does anyone have the part number for the 3.3v voltage regulator on the v5 Lynx Express board. I'm just verifying I am installing the correct part but can't find the number on the item on mousers web site.
Thanks Jeff
-
I don't have it in front of me, but it has two 3's on it, if I remember correctly. Plus, the 5 VR has a 7805 written on it.
-
Does anyone have the part number for the 3.3v voltage regulator on the v5 Lynx Express board. I'm just verifying I am installing the correct part but can't find the number on the item on mousers web site.
Thanks Jeff
879-UPC2933BHFZ
Rick R.
-
879-UPC2933BHFZ
Rick R.
[/quote]
Mine shows a :
LD33CV
GKDVX vw
CHN 918
I know this is it, I just can't find any info on the net about it.
-
879-UPC2933BHFZ
Rick R.
Mine shows a :
LD33CV
GKDVX vw
CHN 918
I know this is it, I just can't find any info on the net about it.
[/quote]Mine also I looked it up in mouser couldn'y find it Searched LD33CV still nothin I know this is the 3 volt part # just don't Jive
-
The version 5 uses part number LD1117V33C as the 3.3 voltage regulator. The pcb is different than previous units so this is the reg for only this version of the pcb. It will not work in other models.
RJ
-
I'm a little confused. The LD33CV I have is correct for the v5 board?
-
I'm a little confused. The LD33CV I have is correct for the v5 board?
If the part you have came with your coop kit it is correct. The numbers stamped on the parts are not always the same as the complete part number. I am not where I can look at one to see the number stamped on it but if it came with the kit it is the correct 3.3v reg. The 5 volt is a 7805 and would not have LD33CV on it.
RJ