Hmm.
I built the ED board and encountered an error in the PICkit 3 program. With the PICkit 3 hardware attached to the board and computer, I receive the following status messages:
- Found 1 firmware suite. latest is version 01.38.51
- Loaded device file with 679 devices
- Found PICkit 3, SN: ...
- Communications error: Could not query PTG mode.
I receive that error with or without the board power supplied from the wall wart. The Device dropdown remains disabled and I can proceed no further.
I did a close inspection of the board and noted a solder bridge between pins 35 & 36 of the Ethernet chip.
I just bought the PICkit 3.
Thoughts? Thanks for any help.
Michael