So long story short I got 2 etherdongles in the lastest coop. Got them both built and only one works.
It will flash ok (verify checks out ok) and the led comes on during the flash but when connected to power the led doesn't come on and no lights on the ethernet jack either.
So here is what I've checked and I'm not sure what is going on.
Getting 8.55 in from the power connector
Seeing 5.0 and 3.3 on the voltage regulators
Pin 1 - 8.55, Pin 2 - 0, Pin 3 - 5 on the 5v regulator
Pin 1 - 0, Pin 2 - 3.3, Pin 3 - 5 on the 3.3 v regulator
50MHZ Oscillator - 3.3v between pin 4 and 8
50 MHZ Oscillator 1.6v between pin 4 and 5
So I got those readings and wanted to double check them so I started going through them all again when I noticed the power on the connector has now dropped to 6.02 instead of the 8.55 like before and the 3.3v regulator was extremely hot (my dad jumped really quick when he touched it
) and saw readings from it of like 0.32. The 5v I was now seeing 4.97
I'm going to go through and retouch everything just seemed wierd that all of a sudden the power dropped and now all the readings are off
Any thoughts?