DiyLightAnimation

Hardware => Lynx Express => Topic started by: Sloanhaus on December 15, 2010,

Title: Express acting strange
Post by: Sloanhaus on December 15, 2010,

This express has worked fine for the last 2 weeks and now it isnt working. The data stream is working as I have it wireless with cat 5 running to another board and the other board is working fine. Both lights 5v and 3.5 are lit up. I run the test and all the channels light up but when I run the sequence, their is no output. I have it on the correct channel as I have not changed anything. Any suggestions?

Title: Re: Express acting strange
Post by: memphislights on December 15, 2010,

tried putting the receiver on the working LE and then getting changing the input to the cat5 from the other one?

Title: Re: Express acting strange
Post by: magic8192 on December 16, 2010,

I had a board that was doing something very near that, but it wasn't wireless.  The problem I see is that the board doesn't always start correctly after a power cycle.  I can usually power cycle it again and it starts working.  Sometimes it takes a couple of tries.    Once it gets going it is fine.

Title: Re: Express acting strange
Post by: memphislights on December 16, 2010,

I did notice that sometimes the LE is hung at power-up as well.  It is pretty random though.