Well, I got this to work (sort of) by setting the dd-wrt router up as a client-bridge and then 'Joined' the Netgear. They are on separate subnets. If I look in the netGear AP I can see both ED which was assigned an IP using DHCP on the dd-wrt router - as well as the wireless dd-wrt client itself. When I bring up the conductor software I can see the show but am unable to control the ED (except for setting the volume level) - even Sync Time does not work. If I move the ED off of the dd-wrt router and plug it into the same switch as the pc - everything works fine! Obviously, something is not getting routed properly. I would have thought that that if the multicast wasn't being routed (and btw, I unchecked the block multicast option in the dd-wrt setup), that I wouldn't even see the ED or its shows with conductor software. Not sure what is happening here! I have two Conductors and the results are the same with either of the two.