I very recently acquired a Smart String hub with 11 blown fuses. The fuses are soldered in on these hubs, so replacing them would be a pain in the best of situations, but the bulk of them are stuck 'way down in between the RJ-45 connectors. Those are going to be a real bear to replace. What I am going to do is install some 2mm banana connectors so if any more fuses blow I can just pull them, solder male plugs on the new fuses, and plug in the new fuses. It will work, but it will be bulky and a bit clumsy. Could we maybe come up with a socket configuration that would allow the fuses to be plugged in, rather than soldered?