Hardware > Lynx MR16 / 16 CH DC Controller

Getting the MR16 going....

(1/1)

Jasonlnlv:
I have setup and got the MR16 I got years ago installed in a box and running - I just used the Lynx Address utility to set it to start at channel 65 it all looked ok - is there a way to check this - before I run all the led floods and it not be right and have to TS outdoors?? Is there a software to check the Dax start address?

Thanks

packetbob:
You can generate a test pattern in Vixen or use the test function in XLights...
Then just use a meter or any sort of light to make sure the correct channels are activated....

Navigation

[0] Message Index