DiyLightAnimation

Software => Light Show Pro => Topic started by: Sloanhaus on June 22, 2009,

Title: Ready for some light action
Post by: Sloanhaus on June 22, 2009,

Set up my sequence, still having that problem when doing RGB, but I guess you are looking into that.

Hooked up my express, set the value to 17 since this is the second board. Went to my device manager to see what port my dongle is on. (it was on 12). I also set the baud rate to 115 (Not sure if I was suppose to do this, I know with Vixen I did. Opened up the software and it asked me what port I wanted to save and I said 12, and left the second part to default 30. Put in some simple lights on each channel and nothing happened. I am pretty sure I just need to set up something right.

Thanks

Brad

Title: Re: Ready for some light action
Post by: rrowan on June 22, 2009,

see if this post helps

check reply #2 and #3

http://diylightanimation.com/index.php?topic=1388.0

RIck R.

Title: Re: Ready for some light action
Post by: Sloanhaus on June 22, 2009,

I go into the output tab and change it from com port 11 to com port 12, and than when I go back into the output it has it as com  port 11 again... I click save every time but it wont save it to com port 12 which is the com port that my device manager says I am using... I feel like super troopers saying com port where they said "meow"

Brad