In the example in the pdf, you state:
PixelNet and DMX ExampleAssume DMX jumper = 3 on Hub 2. Channel 5121 will control DMX channel 1 + any SmartString LED programmed with channel 1025 connected to hub 2.
Can you explain why a SmartString LED connected to hub 2 will be controlled by channel 1025?
The way I have it set up currently is:
Say I have a single 120 node Smart String LED, that gives me 120 x 3 = 360 Channels.
I'd assume that I'd have the Pixel Net jumpers on Hub 1 set to 1 and 1, so any SmartString LED plugged into Hub 1 have an address range any where from 1 to 4096.
So my SmartString LED (the 360 channel string) would respond to the channels from 1-360 and I don't need to set the DMX jumpers on Hub 1, since I don't have any DMX based controllers. Correct?
However, if I did have a mix of Smart String controllers and DMX, then I could leave the Pixel Net jumpers on Hub 1 set to 1 and 1, and also
set the DMX jumpers to say 2 on hub 1 and any DMX devices programmed on channels 513 - 1024 would respond.
Or am I missing something here?