DiyLightAnimation

Hardware => Lynx Wireless DMX => Topic started by: dlhoppe on December 20, 2010,

Title: BOM discrepancy questions
Post by: dlhoppe on December 20, 2010,

I'm sorting parts from Mouser for some Ex/Rx units. It appears the "Mouser Direct" link as well as the manual for the Ex/Rx v2 does not agree with the text-based BOM in the wiki.

The text-based BOM lists the regulator as "511-LD1086V33". See http://diylightanimation.com/wiki/index.php?title=BOM#.23Wireless_TX
The Mouser Direct link and the manual shows the regulator as "511-LD1117V33". See http://diylightanimation.com/wiki/index.php?title=Manual_EXRX

Is the lower current one used for colder temps? I ended up with the 511-LD1117V33 because I used the Mouser Direct link. Is this ok?


Also, Mouser was out of stock on the 140-XRL25V100-RC cap. I found the "equivalent" on the Mouser website as 140-REA101M1EBK0611P. Before I begin assembly, can someone let me know if it's ok to substitute with 140-REA101M1EBK0611P?


Thanks for your help,
Dave

Title: Re: BOM discrepancy questions
Post by: rmp2917 on December 20, 2010,

511-LD1117V33 is the correct part number. I believe the LD1086V33 was used in one of the coops because the original part was backordered. See the following thread.
http://diylightanimation.com/index.php?topic=2944.msg29895#msg29895 (http://diylightanimation.com/index.php?topic=2944.msg29895#msg29895)

You are not allowed to view links. Register or Login

Also note that on the BOM for the Tx/Rx there is an alternate 3V regulator listed, this was done to cover a back order condition with Mouser on the original part.

Bill

The two caps have the same specs. They are simply different suppliers so it should work fine.

Title: Re: BOM discrepancy questions
Post by: dlhoppe on December 20, 2010,

Thank you!