Please provide me with a little more detail on what is working now, i.e. play one show. In particular a directory listing of the file names and their sizes. The show and its contents and the schedule.
When you say you have re-formated the CF card and started over, do you have a directory on your hard drive that contains your .SEQ and .MP3 files? Are you copying these files, .SHO, Password.dat, and Playlist.dat, as well or are you recreating them after only copying .SEQ and .Mp3 files? Are the files being copied as a group (all at once) or individually?
Yes I have a directory called Conductor that contains the .seq and .mp3 files. My Steps are as follows:
1. Quick format Cf Card
2. copy seq and mp3 files to CF card (I have done both 1 and a time and also as a pair.)
3. Opened Conductor Utility
4. Select ok without inserting password
5. Select kingston Flash drive
6. Select and make password using 0207
7. Select make show
8. Name a show test
9. Select 1 sequence and 1 mp3 file
10. Select the next Seq and Mp3
11. Save show
12. Open Schedule: see attached
13. Safe remove CF card
14. Insert card in Conductor
At that point the conductor will come on stating waiting, when the first song starts it will start to count up the seconds. At the end of the song the counting will stop for about 3 seconds then will go to not connected.
After the one song plays and then goes to "Not Connected", what happens after say 10 seconds? Do you notice a periodically flashing (approximately every 5 to 6 seconds) on the Conductor control panel? What is happening with the yellow and green lights on the magic jack when it goes to "Not Connected"?
I have not paid attention to that, but I will tell you that anytime that I remove the CF card with the Conductor powered on the magic jack will go off off=no lights. The only way I can get it back is to change the port on my modem.
Thanks Denny!
Roger