DiyLightAnimation
Hardware => Lynx Zeus => Topic started by: tindivall on November 30, 2013,
-
Not sure where to post this but figured since I am working with the Zues to start here
I am a HUGE newb at this, so bare with me.... Setup etherdongle, wrote the pixelnet hex file to it... then cat5 from etherdongle to zues board.... connected power supply, connected lights... launched the LYNX Smart String V2 .... tell it program with etherdongle, device = zues, all, put in node count... transmit....
lights start blinking white really fast over and over.... click stop and they keep blinking... only way to turn off is to power down the power supply to zues board.....
is this normal? or when I hit stop shouldn't they stop?
-
No that is normal.
-
Normal, once you hit the submit and programmed. Hit stop and power off the Zeus. Then move the program jumper off and turn the Zeus back on.
-
Yes
-
Yeah so I might have missed that whole moving program jumper etc <fp..... can anyone help explain that as I am not proficient and don't want to screw the board up?
do I just pull the blue tab off the area that says program?
-
also when I open the SS V2 for the Zues I do get an excpetion: Could not find file ......C:\....\...\...\....\DLA\Smart String Utility\1.0.0.0\config.xml
do I need to download this from somewhere?
-
Yeah so I might have missed that whole moving program jumper etc <fp..... can anyone help explain that as I am not proficient and don't want to screw the board up?
do I just pull the blue tab off the area that says program?
You can just move it so it sits on one post instead of both posts like when programming. That way you don't lose it. I don't have a Zeus so I can't help with your error.
-
<wd.. Thanks for the help, the whole moving the program jumper fixed everything!!!!
-
also when I open the SS V2 for the Zues I do get an excpetion: Could not find file ......C:\....\...\...\....\DLA\Smart String Utility\1.0.0.0\config.xml
do I need to download this from somewhere?
http://www.diylightanimation.com/wiki/index.php?title=Equipment#Smart_Strings
library...software
there is two options depending on if you have v3 of ssc firmware. Install from this then rename the zeuss one so you know which one is which and then put in the same directory as the install. The one with zeuss is just the exe not the install which installs the dependencys