DiyLightAnimation
Software => Light Show Pro => Topic started by: PIC on November 25, 2012,
-
I have 2 zones setup and tested fine in LSP. (Exact same as my vixen PC)
Zone 1: Ren64+Ren24 channel 1-88
Zone 2: Ren64+Ren16 channel 1-80
I test controller output and it worked great.
However when I try to playback in LSP I get erratic results. Sometime zone 1 works only, zone 2 only, and no zones. I did run a temp cable to try to put all on one zone and got it to work. I would rather get this to match my Vixen setup since I have vixen running now until I get the bugs out of my new LSP PC. Any ideas on what to check.
Sent from my iPod touch using Tapatalk
-
My understanding is two zones are only required if you are using two different protocols. Since you have the same protocol, you should be running only one zone.
-
Can I have 2 different com ports on one zone? I am not sure how to do that. Any ideas how to set it up?
Sent from my iPod touch using Tapatalk
-
I would like to know also, as xLights doesn't like the 2 zones for my 2 Lynx dongles when I convert them, so have to program all the controllers on zone 1, which causes issues if I try to play a sequence in LSP.