DiyLightAnimation

Hardware => Lynx Wireless DMX => Topic started by: RJ on October 11, 2009,

Title: Building a TX
Post by: RJ on October 11, 2009,

When building the TX do not get carried away with a lot of solder on the AMP as it can get under the amp and short out on the heatsink underneath it. You want a little to get under but in this case "a dab ill do ya!"

If this happens your 10 ohm resistor will get real hot and this is a clue.

RJ

Title: Re: Building a TX
Post by: Blackbeard on October 23, 2009,

Are you using Brylcream or solder?

steve