Okay I know many of us are having some type of issue during our setup. I have another similar problem I'm hoping someone can shed some insight on.
My set up goes like this:
PC to dongle
Dongle to wireless TX
LE 1 confirmed wireless RX and receiving data. All Channels in LE 1 (1-16) work. Terminate jumper NOT on. DMX OUT 1 has cat 5 to LE 2. ( have swapped over to DMX out 2 with same problem).
LE 2 cat5 cable plugged into DMX in. Test button on LE 2 works and controls all lights. Terminate jumper ON, (have tried removing jumper, problem still exists).
No lights will work on LE 2 with Vixen sequence or Vixen channel test. I have rebooted PC, LE 1, LE 2. The only thing I have not done because it was snowing hard and I already was working in 4 inch's of snow and it was almost midnight is replace the cat 5 cable. Any other suggestions? Tonight I will replace cat 5 and check out. If problem still exists I will swap out with spare LE and see if problem is still there. I still have 6 more LE's and 10 SSR4xDMX to connect and time is running short. Any help would be great.
Freebird