DiyLightAnimation
Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: shaunkad on November 10, 2012,
-
Can I bare bone program an mr 16 pic it is an 18f like the dongel? I may be selling it in kit form and I am not sure if the buyer has a pic kit.
-
Yes
I think there is a example in the wiki
Rick R.
-
Yes its but it did not say mr 16. The pic is also a little different.
Thank you
shaun
-
try this page then
http://www.diylightanimation.com/wiki/index.php?title=Pickit_Pic18f1220
Rick R.
-
The MR-16 PIC is physically smaller than the other PICs in other controllers.
I tried programming one in my 28pin socket and it didn't work.
I had to put it in the smaller socket to program. (18 pin).
There is a 28 pin chip on the MR-16 but you can't / don't program it. It is an LED driver chip (4096 step grayscale)