I've completed my board with the exception of the row of cable headers. Short of using a hammer or a pair of pliers or drilling out the holes a bit, I don't see how I'm going to get these to fit. I've taken them apart and tried them separately without success. I've already started to bend pins trying to get them to fit.
I can't believe I got everything else on the board completed and can't figure this out. I guess I'm not as smart as even I thought I was!
On the bright side, I ran the power check and got my green lights like I was supposed to. I'm debating now whether to install all the chips and do a full test which should be OK without the cable headers installed. I just don't want to have to remove the chips in order to solder in the headers once I figure that out. Any thoughts?