I had problems installing the 485 chip to the right of RJ45 Connector. I did a continuity test on pin one and it said it was connected to pin6 and pin7 of the same chip. I was wondering if Pin1, 6, and 7 were supposed to be connected. I ran the built in test and all channels worked and the ZC led came on but the DMX LED did not and the Lynx Express Configuration Utility can not communicate to the LE, I also tried the dongle test in VIxen and I saw the dongle led lightly blinking and the LE led looked like it was slightly blinking but none of the information gets past that. Thank you in advance.
Adam