DiyLightAnimation

Software => Light Show Pro => Topic started by: kevinpickett on June 14, 2012,

Title: Connect AL boards to LSP
Post by: kevinpickett on June 14, 2012,

What needs to be done to use the LOR USB485B as a dongle to connect non-DMX Animated Lighting boards to my PC to run with Light Show Pro?  Do I need to make any special cat 5 cable to compensate for the difference in the grounding pins between LOR and Animated Lighting?  Are pins 4 & 5 the same transmit/receive or do they need to be crossed?

Thanks
Kevin

Title: Re: Connect AL boards to LSP
Post by: MrChristmas2000 on June 14, 2012,

There are more Animated lighting experts over on the LSP board.

Title: Re: Connect AL boards to LSP
Post by: urthegman on June 14, 2012,

I know that for Animated Lighting, the green and green and white striped wires get twisted together and go to the GND pin on your dongle, the blue and white goes to T- or D- and the blue goes to T+ or D+.  Hope that helps.

Title: Re: Connect AL boards to LSP
Post by: kevinpickett on June 15, 2012,

Thanks for info.

Title: Re: Connect AL boards to LSP
Post by: RJ on June 16, 2012,

Surprise!

we get experts from all of them at dla!

:-)

Sent from my Charge by Tapatalk

RJ