DiyLightAnimation
Hardware => Lynx Aether => Topic started by: urthegman on August 06, 2012,
-
Does an Aether II need to be hooked up to any type of controller? Or can I just hook it up to a 12V power source and send it a signal from a DMX splitter ? What type of controller would I add to my sequences in LSP? Thanks, George
-
Hi George,
The Aether is a 4 channel DMX device so you could just create a RGB device but you would loose one channel So just creat a new device in LSP that has 4 channels and is DMX controlled.
-
The Aether is a self contained DMX device. Give it a starting address, supply it power and hook it up to the DMX data stream and your good to go.
-
The LYNX Aether II is a DMX device. You can use any DMX device that LSP supports.
It is an RGBW device that takes 4 DMX addresses. You can set the beginning address using the address utility located here: http://diylightanimation.com/index.php?action=dlattach;topic=2676.0;attach=2607
-
Thank you all, I was going over my set-up in my mind and thought wait a minute, what controls the Aether II??? Now I know!!!
-
Is it RGBW in that order, correct?
-
It's not in the manual or anywhere in the wiki but I would assume that it would be
Address 1 R
Address 2 G
Address 3 B
Address 4 W
User your softwares hardware test to verify this.
-
That is correct.
Sent from my Thunderbolt using Tapatalk 2.