DiyLightAnimation
Hardware => Lynx Express => Topic started by: BryanV on September 20, 2009,
-
Just wondering if I can install jumpers on the terminal blocks where the power cords attach to instead of under the board. It would be a little easier to undo the modification if I decide to jump up to 40 amps. Any ideas.
-
I usually just take one big jumper (a piece of power cord) and install it between the two power blocks. Just remember that you will be limited to the power capabilities of the wiring/cord you are using. You will not be able to get the rated 40 amps out.
-Paul
-
Jumpers are the way I do it...
John
-
thanks, i figured that would be the easier way to mod the power.