DiyLightAnimation
Hardware => Lynx EtherDongle => Topic started by: Christmasaddict on November 11, 2012,
-
Have built an EtD and flashed the PIC. As far as I can tell it is working properly however I am getting no output to my LE. I am using Light Show Pro V2.5. Do I need additional hardware? Hub?? I'm not sure what to do next.
-
In LSP have you configured your controllers to output E 1.31?
Secondly, once you get the E 1.31 set, you have to go to "Configure Controller Output Plugin." In that process you select "Multicast (Lynx Express ...)" It will set up a bunch of channels and universes for you to use.
From there you should be golden to output to the LEs.
My assumption is that you have flashed the EtD with DMX - if it is flashed for Pixelnet, you have to go through an SS Active Hub and set the controllers(LEs) up differently.
-
In LSP have you configured your controllers to output E 1.31? Yes using "Configure Outputs"
Secondly, once you get the E 1.31 set, you have to go to "Configure Controller Output Plugin." In that process you select "Multicast (Lynx Express ...)" It will set up a bunch of channels and universes for you to use. I went to "Configure Controller Output Plugin" but not sure if I did everything properly
From there you should be golden to output to the LEs. Still no output
My assumption is that you have flashed the EtD with DMX - if it is flashed for Pixelnet, you have to go through an SS Active Hub and set the controllers(LEs) up differently. Yes, I did flash with the DMX firmware.
-
GOT IT!!! I went back through the configuration and realized what I had done wrong. I am now getting DMX to my first LE. Will check and be sure it is outputing to the other 2. THANK YOU SO MUCH FOR YOUR HELP!! :)
-
Now outputting to all 3 of my LE's. Thanks so much to everyone who helped me through this process. Now I can't wait to get my hands on a Conductor PCB for next year...
-
What was wrong ?