DiyLightAnimation

Hardware => Lynx Express => Topic started by: wrxin on October 31, 2011,

Title: Problem with new lynx express
Post by: wrxin on October 31, 2011,

This is my first lynx express. Just finished the assembly. The two LEDS (5 and 3.3) light up fine but I have a dimly lit number six LED and the display does not work. Pressing and holding reset turns off the number six LED but it dimly lights again when I release the button.

I have not programmed the chip yet.

I'd really appreciate any help.

Thanks

Title: Re: Problem with new lynx express
Post by: KeithTarpley on October 31, 2011,

Greetings,,,

That should change for the better after you program the chip.

Keith

Title: Re: Problem with new lynx express
Post by: barbotte on October 31, 2011,

make sure you look at your solder joint where the led are dim .. i had the same problem on 1 led ans i guess i had cold fusion as i re heat the defect joint and voila everything work flawless ... as i was told yesterday ... the chip were program by RJ so i don't think it is the chip program ...

Title: Re: Problem with new lynx express
Post by: wrxin on October 31, 2011,

Thanks for the help. I'll program the PIC and see how it goes.