DiyLightAnimation

Hardware => Lynx Express => Topic started by: jay9158 on December 06, 2014,

Title: 240v conversion
Post by: jay9158 on December 06, 2014,

hi can anybody tell me which are the correct resistors to change and is it 330k ohm 1/4w or 100k ohm 1/2 to be used

Title: Re: 240v conversion
Post by: tbone321 on December 06, 2014,

The conversion steps can be found in the LE's manual in the WIKI.
http://www.diylightanimation.com/wiki/index.php?title=Manual_Express

Title: Re: 240v conversion
Post by: jay9158 on December 15, 2014,

hi i did read it but there is a section at the top and bottom of page that says the 180 ohm should be changed to 330 ohm and the 47k to 100k , it also mentions a dot next to 180 ohm resistors my board does not have these dots. just wanted to double check before i commence

Title: Re: 240v conversion
Post by: tbone321 on December 15, 2014,

What version of the LE do you have?

Title: Re: 240v conversion
Post by: jay9158 on December 16, 2014,

hi it says on the board ver 5.0.
i am changing the 16 47k ohm to 100k ohm and the 16x180 ohm to 330 ohm is this correct as just about to finish building