DiyLightAnimation

Hardware => Lynx EtherDongle => Topic started by: mmciver on August 18, 2014,

Title: question, but not sure it is i right place !!!
Post by: mmciver on August 18, 2014,

my configuration is as follows.
computer - etherdongle - Smart Hub - LE - LE

I am currently running a chase test from Light Show Pro V2.8
Channels 1-512 are defined on smart hub as my DMX space.
I have a 512 channel Pixelnet controller setup in LSP..

Channel 1 on my LE is not showing up.  It looks like everything is shifted a channel.
has anyone run into this?

Mike

Title: Re: question, but not sure it is i right place !!!
Post by: tbone321 on August 18, 2014,

I would look into the configuration of the 1st LE and the setup in LSP.  Make sure that the LE is actually set to channel 1 and that your PixelNet universe is set up correctly in LSP.  Also make sure that the ETD is flashed with Pixelnet firmware.

Title: Re: question, but not sure it is i right place !!!
Post by: mmciver on August 24, 2014,

finally rechecked my configuration and saw that my first LE was set with start channel 0 instead of 1.  Changed it and things are working fine.

Thanks for the pointers!

Mike