DiyLightAnimation

Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: mmais68569 on November 30, 2011,

Title: MR 16 Resistor Question
Post by: mmais68569 on November 30, 2011,

I bought 3 MR16 from a member on the board that were to have come from a coop. My question the resistors that I have are color Brown/Black/Red/Gold & Brown/Gray/Brown/Gold. Neither one of these fit the colors for the 4.7 & 120 resistor. Are these replacement resistors or do I need to get the correct ones. These are v2 boards & BOM.


             Thanks Mike

Title: Re: MR 16 Resistor Question
Post by: JonB256 on November 30, 2011,

That's a 1kohm and 180ohm by my calc.

Title: Re: MR 16 Resistor Question
Post by: mmais68569 on November 30, 2011,

That is what I figured also.

         Mike

Title: Re: MR 16 Resistor Question
Post by: mokeefe on December 01, 2011,

I was in the recent MR16 coop and received 4.7K, 1K, 1.2K, 180, and 120 resistors (in addition to the 16 3k's).  The V2 board has spots for one each of the 4.7K, 1K, 180, and 120 resistors.  Not sure what the 1.2K was put in for (it's not in the BOM) unless it was for use if you run the board without MOSFET's.  The manual in the Wiki is out of date as it refers to the V1 board so it is missing some of these resistors.

-Mike

Title: Re: MR 16 Resistor Question
Post by: rmp2917 on December 01, 2011,

The 1.2K resistor was on the BOM that I was using for the Co-Op. It is not needed and the BOM in the Wiki has since been updated.