DiyLightAnimation

Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: Jasonlnlv on September 16, 2015,

Title: Will this Power Supply be OK on the MR16
Post by: Jasonlnlv on September 16, 2015,

So I have revived the use of the MR16 but have a Power Supply that I want to use but not sure it will work with it.

It is a:
SWITCHING POWER SUPPLY - 150 W - 12 VDC
info here: http://www.velleman.eu/products/view/?country=be&lang=en&id=411746
http://www.velleman.eu/products/view/?country=be&lang=en&id=411746 (http://www.velleman.eu/products/view/?country=be&lang=en&id=411746)

I'm going to run 16 small LED Floods on it.

Title: Re: Will this Power Supply be OK on the MR16
Post by: t.jo13 on September 16, 2015,

Thats a hard question to answer not knowing the amp draw of each flood. The power supply itself will work on the mr 16 but the supply is only rated at 12.5 amps max .You will need to figure out how many total amps you need to know if the power supply  will work.

Joe