Hardware > Lynx Freestyle

Changing a Freestyles DMX address

<< < (2/5) > >>

MrChristmas2000:
Ok, I changed those locations (see graphic).

Still the Freestyle starts at address 1.

Any other ideas would be appreciated.

tbone321:
Are you sure that you actually wrote this to the device?  You checksum has not changed although I'm not sure if EPROM data is included in the checksum value.  I would shut down everything and restart the software and reread the PIC and see if the new values are still there.

rrowan:
After a write I would do a read to verify that the chip has the correct address.

Rick R.

MrChristmas2000:
I reconnected my Programmer module, pulled the chip out of the Freestyle and put it in the Programmer socked. Fired up the PICkit2 software, did a read and here is the resulting dump. (attached).

tbone321:
RJ may need to get involved in this.  He may have a default value of 1 if it cannot resolve a correct address.  If he is just adding the two memory locations, you could try reversing the two entries and put the 02 in position 2 and the FF in position 4.  You could also keep the first entry in position 2 but make it FE and change the value in position 4 to 03.

Navigation

[0] Message Index

[#] Next page

[*] Previous page