OK. Reformatting the card resolved the "error."
Now another issue.
When I start my show nothing happens for about 6-8 seconds and then lights come on. The sequence has lights turning on at time zero. When lights do come on they seem to play correctly for the brief test I created; 22 sec long. I am using LSP and have the most recent version to convert to Conductor format. I reflashed my PIC on the Conductor and the Active Hub. My SSC is V1 (is that an issue?).
Sounds like you have a set up almost exactly the same as mine. Mine is:
1. LSP
2. Export to Conductor format
3. Onto flash card
4. Insert into conductor
5. Conductor on to the Ether dongle
6. Etherdongle to Active Hub
7. Active Hub to SSC v1 (yes I'm still on version one and they work just fine for me)
The lights should come on when you command them to do so and match what you have sequenced in the LSP sequencer
When I start a manual playback using the Conductor Control Panel from a remote PC, the sequence starts in a couple of seconds and works fine. I haven't started a show yet using the Conductor scheduler yet, but I'd expect it to be the same as if I started it manually.
Are you trying to turn the lights on at EXACTLY time zero (meaning right at the beginning of the sequence), I thought that with LSP you should not have an effect at exactly zero (perhaps 50mS after the start of the sequence, but not one at exactly zero)