I obtained a used DLA EtherDongle from one of the forum members, but it is DOA. I tried re-flashing the PIC, but the controller can't even find it. I verified the setup is good by flashing another ETD with no problems, at all, but every operation with the PICKit 3 fails on the new board. I cleaned the board thoroughly and inspected the traces, but I don't see any evident solder bridges, cold solder joints, lifted pads, or cut traces. Unless I am missing something, that pretty much leaves the PIC itself. I wonder if anyone in DLA land has an SMD reworking station and woud be willing to take a stab at replacing the PIC?