DiyLightAnimation

Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: Jasonlnlv on November 15, 2012,

Title: MR16 completed Pictures and question of use
Post by: Jasonlnlv on November 15, 2012,

Does anyone have a picture of the MR16 completed and how the power supply and light connectors are hooked up?

Also as far as use - is it only able to run floods or can I connect regular lights on a few channels to use on some overflow needed from my express cluster?

Thanks for any input.

- Jason

Title: Re: MR16 completed Pictures and question of use
Post by: KeithTarpley on November 15, 2012,

Greetings,,,

The MR16 is designed for low voltage, such as 12V, DC only lights.  Not the AC lights that are used with Expresses.

Keith

Title: Re: MR16 completed Pictures and question of use
Post by: hicksjo on November 15, 2012,

did you look at the wiki for the picture?
http://www.diylightanimation.com/wiki/index.php?title=Image:SmMR16v2.jpg

Title: Re: MR16 completed Pictures and question of use
Post by: Jasonlnlv on November 15, 2012,

Yes thank you - I did see that one - I was looking for pictures of the power supply hooked up and the channel wires connected and the lights connected to it ... Kind of a live use pic....

I bought one of these last year before I really knew what it's use was and was trying to see how to use it this year...

Thanks for the replies!

Title: Re: MR16 completed Pictures and question of use
Post by: JonB256 on November 15, 2012,

Be SURE! (voice of experience) that when you connect some Common Positive RGB lights, that you actually connect the single Positive wire to the Positive side and the other 3 wires (Red, Green, Blue) to the Negative side.

Otherwise, it won't work.