DiyLightAnimation

Hardware => Lynx EtherDongle => Lynx Conductor => Topic started by: cavu2u on December 17, 2012,

Title: FYI: Etherdongle will not connect when non-operational Conductor is attached
Post by: cavu2u on December 17, 2012,

I have Conductors that will not connect to the control panel - that issue is addressed in different threads.

With the failure of my Conductors, I fell back to using xLights for scheduling.

For several days, I chased "bad" cables that I could not get to connect once the plain DMX firmware was flashed onto the Etherdongle to use with xLights. My "bad" cables might connect for one performance(schedule) or a partial schedule.

One night I removed the non-operational Conductor and viola, I had a solid connection that no longer was intermittent. That was 5 days ago. I've had a rock-solid connection ever since. I suppose my assumption was that if the dongle was flashed with the DMX firmware, it would disregard errant signals from an attached daughter card.

So, be advised ... If your Conductor will not connect to the control panel, exhibits the connect/disconnect behavior addressed in other threads, remove it from your Etherdongle to use DMX reliably.

Title: Re: FYI: Etherdongle will not connect when non-operational Conductor is attached
Post by: rrowan on December 17, 2012,

Sounds like you have a soldering problem(s) with the conductor causing errors on the etherdongle.

Rick R.