Frank, found some errors on my part in E1.31 mapping that caused the matrix to put things in the wrong rows.
Probably the biggest problem is I split my ECG-P12R into 12 separate controllers and replacing those 12 with one 5040 channel monster in zone 3 got all of that working.
The LOR like you said never has a problem, but on the DMX side I was still dead even though the xlights tester lit up Arch segment Ch 81 fine, but DMX never went out during sequence play. The fact the xlights tester does Net#2 DMX channel 81 fine, and also the RGB Aether 2 on 400 to 402 channels, but the sequence doesn't output DMX playing a sequence is a mystery still.
So the "DMX is 80 channels off on the wire" got me to thinking about the ONLY problem I really have is DMX never maps correctly with my setup. So I put my DMX first in the xlights setup with 406 channels, then I listed the LOR, then all the E1.31. DMX is set for Zone 1, LOR is set for Zone 2 (it never maps wrong), and E1.31 is Zone 3.
I just tested it and DMX, LOR, and the matrix worked fine. Perhaps it's the fact I'm starting my DMX at channel 81 instead of channel 1 that's throwing it off, but with the coroflake devices and reprogramming them all would be a lot of work once I got them off the house.
Now to throw another sequence in and see what happens. I'd like to understand why LOR listed first with DMX second doesn't work, but when I reverse them and rezone them accordingly it works?. I attached a screenshot of the working xlights config.
Frank, I can attach the working and non-working xseqs if you want... I'm guessing it's the DMX 81 channel start?