DiyLightAnimation
Hardware => Lynx Wireless DMX => Topic started by: bisquit476 on February 09, 2010,
-
The EX/RX transceiver has a note on the package to bake the chip before soldering, is this required?, at what temp?, for how long?
-
No need to worry. Baking is only needed if you are reflow soldering it in an oven. If you are using a soldering iron, it's not needed.
/mike
-
Thanks Mike, I thought that was the case, but since I have no way of testing them yet (RJ - hope the beta TX/RX boards are testing well), I didn't want to build any more boards until I verified it. Thanks again,
Bill