I'm not sure, but I may have already posted these details -
Here are the instructions for my wiring - refer to the photo.
There are 9 square modules in each leg. I spliced lengths of wire to better center the squares into each 'petal' (don't know what else to call them).
Here is the layout (refer to picture):
1) Between squares 1,2,3,4 -normal spacing
2) Between squares 4,5,6,7,8,9 - add a 10" length of wire (could probably shorten, but I wanted plenty of room)
3) After square 9 - Take 20" of wire and attach it to square one of the next leg.
4) (see arrow) - Separate the red, blue and green wires.
5) Connect the other end of the GREEN wire to sq 9. ONLY the GREEN data wire connects between sq 9 and sq 1 of the next leg.
6) the Red (V+) and Blue (Gnd) wires are tied back to the power supply