Thanks so much Bill, got my package today, made the wife go get it, since i had to work, and when i got home she made me open it to see what was so important that she had to go get!!! this should be fun. is their an updated video or manual on assembly? once again thanks so much!joshua
9 Payments remain to be received for cases. If payment for cases is not received by Monday at 8:00 P.M. EST those cases will be dropped from the order.Bill
You are not allowed to view links. Register or LoginThanks so much Bill, got my package today, made the wife go get it, since i had to work, and when i got home she made me open it to see what was so important that she had to go get!!! this should be fun. is their an updated video or manual on assembly? once again thanks so much!joshua There is not one yet for the ver 2 units. Read over the manual for the ver1 and the only differences are that you do not modigy the RF module(cut) there is not amp chip or antenna it is on the module, there is an extra three pin jumper to choose if it is a Rx or TX and there are two leds and resistors for them but the rest is all basicly the same. The silk screen on the pcb shows where to put everything and with a read over of the ver1 manual you should have no difficulties. RJRJ
You are not allowed to view links. Register or LoginYou are not allowed to view links. Register or LoginThanks so much Bill, got my package today, made the wife go get it, since i had to work, and when i got home she made me open it to see what was so important that she had to go get!!! this should be fun. is their an updated video or manual on assembly? once again thanks so much!joshua There is not one yet for the ver 2 units. Read over the manual for the ver1 and the only differences are that you do not modigy the RF module(cut) there is not amp chip or antenna it is on the module, there is an extra three pin jumper to choose if it is a Rx or TX and there are two leds and resistors for them but the rest is all basicly the same. The silk screen on the pcb shows where to put everything and with a read over of the ver1 manual you should have no difficulties. RJRJThanks RJ,my only concern is the RF module, i have not done any surface mount, how hard is it to do? should i use a griddle or use the soldering iron as suggested in version 1?Thanks