DiyLightAnimation

Hardware => Lynx EtherDongle => Lynx Conductor => Topic started by: sittinguphigh on November 25, 2012,

Title: New etherdongle and conductor firmware programming.
Post by: sittinguphigh on November 25, 2012,

I just built my etherdongle and conductor. Ready to connect the two. Do I program the etherdongle before or after I 
I connect the two.

Title: Re: New etherdongle and conductor firmware programming.
Post by: dpitts on November 25, 2012,

It does not matter.

Title: Re: New etherdongle and conductor firmware programming.
Post by: sittinguphigh on November 25, 2012,

Thanks

Mort

Title: Re: New etherdongle and conductor firmware programming.
Post by: tbone321 on November 25, 2012,

it is easier to connect the Programmer before you connect the two together but as said, it doesn't matter otherwise.

Title: Re: New etherdongle and conductor firmware programming.
Post by: keitha43 on November 25, 2012,

What I did was test my etherdongle first using its firmware to make sure it was working 100% before reflashing with conductor firmware and testing that.

Sent from my Thunderbolt using Tapatalk 2.