Hardware > Lynx MR16 / 16 CH DC Controller
MR16 Programed Channel Test
SteveMaris:
JonB256,
When programming the start address as you mention, does that then change the checksum?
I tried this last night (It worked) but I just want to be sure...as I have 3 more mr16's to program.
Thanks...
chrisatpsu:
yes, any time you change a value of the firmware, it changes the checksum of the firmware.
SteveMaris:
Thank you Chris, and thank you Jonb256, I spent over an hour trying to set a start channel the conventional way and finally stumbled across this thread. <res.
JonB256:
Glad it helped. I added a NOTE about the changing checksum in my directions.
Navigation
[0] Message Index
[*] Previous page
Go to full version