I am able to run a show on the conductor using the conductor panel.
I get music but no blinky from the test sequence I put together. I used LSP (newest version that supposed to fix conductor output) to convert to conductor format.
The Etd/Conductor is attached to my Active hub (reflashed hub's firmware tonight just to make sure it was correct).
My test sequence's only controller is an LE. It has been tested and works with USB dongle.
I have attached the DMX output on the hub to my LE's DMX in. The controller channel numbers are correct.
The DMX universe on the hub is set to 1.
No lights when I run the show but when I turn off the Active Hub I may get a very brief flash of lights from the LE.
As a test, I reflashed the EtD to be pixelnet (not conductor) and used LSP to test my controller; no lights there either. Suggests Hub is issue but I tested SSC hardware with the hub last spring and had no issues.
I then took the EtD flashed it to DMX and using LSP to test the controller I got lights. This proves at least the EtD is working.
Clear as mud? Any ideas? Thanks.