Hardware > Lynx Express

LE problem

(1/4) > >>

Brad:
Hi All,

Fired up my 2nd LE last Sunday and had 4 ch's not working. #2,#13,#14,#15. Checked the bottom for cold solder joints. Lifted a couple opto's to check for bent pins, all okay. Made sure all opto's were seated properly.
Any thoughts?

Brad

rrowan:
You are not allowed to view links. Register or LoginHi All,

Fired up my 2nd LE last Sunday and had 4 ch's not working. #2,#13,#14,#15. Checked the bottom for cold solder joints. Lifted a couple opto's to check for bent pins, all okay. Made sure all opto's were seated properly.
Any thoughts?

Brad

--- End quote ---

Hi Brad

The four channels not working did you have light sets connected or just looking at the on board leds?

if just the leds I would bet they are in backwards (don't ask me how I know this :))

Oh, did you run the on board test mode?

Rick R.

Brad:
Rick,

I had lights attached. I used "all ch's on" in Vixen as well as had a 1 min sequence running. Nothing wrong there. LE #1 worked fine with the same sequence.
I will look at the LED's when I get home from work.

Brad

memphislights:
If you are still having problems, can you post a pic of the bottom of the board?

RJ:
Let us know what you are seeing so we can help.

RJ

Navigation

[0] Message Index

[#] Next page