Hardware > Lynx SSR4

Brand new SSR4 start address.

(1/4) > >>

chrisatpsu:
when the pic is flashed, is it already set for channel 1?

tbone321:
I do believe that is the default setting.

chrisatpsu:
i'm asking because i think it might be set for channel 0 to start off.

i can't find the value 0001  in the hex file.

tbone321:
That depends on how the firmware was written but a zero could be interpreted as a default or one since there is no channel zero. 

dmaccole:
Just yesterday I encountered a brand new chip from a coop that had never had its address set coming up at Channel 5 for some reason.

FWIW, I programmed/re-programmed five DMX SSR4s yesterday and found that I got the most consistent results with Option 2 and xLights' Light Tester with the dimming command to set and then the alternating command to check to make sure the start address took.

\dmc

Navigation

[0] Message Index

[#] Next page