Hardware > Lynx SSR4

Help needed in assembling smart string active hub

(1/1)

danj:
I have looked around but did not find a topic on this subject.  Stupid question---for the 8 pin and 6 pin headers, do the "long" pins go "up" on the board with the "short" pins soldered to the bottom?  I think the answer is yes but wanted to check before I soldered!!!  Thanks very very much in advance.

Edit--I figured it out.  "Long" pins have to go up to provide enough pin length for the jumpers to be installed.  Doh.

CaptainMurdoch:
Yes.  The tall sides stick up in the air away from the front side of the board for installing jumpers and attaching a programmer.

danj:
Finished the first one.  I have only built a few boards, so I am slooooow.   But I am getting better...   Little by little.  It is kinda fun learning how to solder.  Woulda never figured I would be a solder-dude!!

Second one next weekend.  Woohoo!!!

By the way, thx Cap.

Navigation

[0] Message Index