I am looking for a little help with my etherdongle setup. I built the dongle and flashed the pic, it appears to be connected to the system. If I run a test sequence in LSP the data light on the ED starts to flash at a different frequency so I think it is working. I followed MICKPATs instructions to set everything up but I still don't seem to be getting any DMX out of my smart hub. I have the jumper on the hub set to universe 1 and I ran a cat 5 cable from the DMX out on the hub to the DMX in on the Lynx express. When I run the test sequence on the express, it doesn't seem to be getting dmx signal.
I put on the jumper to disable wireless and the terminate jumper with no success. Any ideas?