DiyLightAnimation
Hardware => Lynx USB DMX Dongle => Topic started by: cpnbnanamn on April 24, 2010,
-
Ok... Just finished building my first controller (V5). It seems to be working so far. Now I need to getting it running. I have a DMX dongle Version 1 board (unassembled), but I'm trying to figure out if it'll be sufficient for my Version 5 LE. I know the changes that were made from V1 to V2, (status lights, test mode for example)... Will a V1 dongle work for this, or do I absolutely need to get the V2?
-Roger
-
Greetings,,,
Both put out DMX. The V2 has a couple of extra bells and whistles. But both work to put out a DMX stream. That's what's needed.
Keith
-
So the version 1 would be sufficient? Data steam is fast enough, etc? Sorry, just learning..
-Roger
-
Greetings,,,
Yes, there's no difference in the DMX speed itself. Both work correctly. A few minor extras were added to the V2 pcb, but that is all. V1 works just fine. With the massive amount of pcbs ordered for the last Coop, there was a chance to make a few small changes that can be helpful, but not needed to do the job. That's the only difference.
Keith