DiyLightAnimation
Hardware => Lynx EtherDongle => Topic started by: pk on April 28, 2012,
-
I have the etherdongle. I have it working on channels 1-4096. What do I need to do to get channels 4097-8192 in the second universe to work? What channels do I assign to the SSC's in the second universe?
I have been trying to get this to work but have been unsuccessful.
-
Jumper your second hub to pixelnet universe #2 and plug the ssc's for the second universe into that hub. Then in vixen it is channels 4097 - up but the sscs are set for channel 1 - 4096 .
Hope this makes sense.
RJ
-
Thanks RJ. Yes, that makes sense. In Vixen, do I setup the EtherDongle output plugin as channels 1-8192?
Part of the problem I was seeing... I neglected to solder the PixelNet IN connector. <fp. It works much better when soldered!!
-
yes. And we have all done it before.
-
Thanks RJ. Yes, that makes sense. In Vixen, do I setup the EtherDongle output plugin as channels 1-8192?
Part of the problem I was seeing... I neglected to solder the PixelNet IN connector. <fp. It works much better when soldered!!
Funny that, I had some issues with the DMX channels coming off one of my Active Hubs.The lights connected to the DMX channels would flash on an off randomly. Then I discovered that I forgot to solder the connector supplying the DMX signals. <fp.
Soldered it up and all the lights started working properly.